Speed Bumps And Speed Humps

Intersection Humps/Raised Intersections
continued from Raised Crosswalks

Intersection humps raise the roadway at the intersection, forming a type of “plateau” across the intersection, with a ramp on each approach.  The plateau is at curb level and can be enhanced through the use of distinctive surfacing such as pavement coloring, brickwork, or other pavements. In some cases, the distinction between roadway and sidewalk surfaces is blurred. If this is done, physical obstructions such as bollards or planters should be considered, restricting the area to which motor vehicles have access.

Design Considerations:
• Ramps should not exceed a maximum gradient of 16 percent.
• Raised and/or textured surfaces can be used to alert drivers to the need for particular care.
• Distinctive surfacing helps reinforce the concept of a “calmed” area and thus plays a part in reducing vehicle speeds.
• Distinctive surfacing materials should be skid-resistant, particularly on inclines.
• Ramps should be clearly marked to enable bicyclists to identify and anticipate them, particularly under conditions of poor visibility.
• Care must be taken so the visually impaired have adequate cues to identify the roadway’s location (e.g., tactile strips). Color contrasts will aid those who are partially sighted.

Next… Traffic Calming - Reducing Street Area Where Motor Vehicle Traffic is a Priority.

Raised Crosswalks

(Continued from Bumps, Humps, & Other Raised Pavement Areas)

Raised crosswalks are essentially broad, flat-topped speed humps that coincide with pedestrian crosswalks at street intersections. The crosswalks are raised above the level of the roadway to slow traffic, enhance crosswalk visibility, and make the crossing easier for pedestrians who may have difficulty stepping up and down curbs.

Raised Crosswalks Design Considerations:
• Can be constructed of brick, concrete block, colored asphalt or cement, with ramps striped for
better visibility.
• Raised crosswalks are applicable:
(1) On roadways with vehicular speeds perceived as being incompatible with the adjacent residential                       land uses.
(2) Where there is a significant number of pedestrian crossings.
(3) In conjunction with other traffic-calming devices, particularly entry treatments.
(4) On two-lane or fewer residential streets classified as either “local streets” or neighborhood
collector streets.”
(5) On roadways with 85th percentile speeds less than 45 mph.

Next… Intersection Humps/Raised Intersections